1. Hang the alloy saw blade vertically on a dry shelf, avoiding humid places, and do not place the alloy saw blade flat on the ground or on the shelf, as flat laying will cause the alloy saw blade to deform.

2. When using, do not exceed the specified speed.

3. When in use, wear a protective cover, gloves, safety helmet, safety shoes, and protective glasses.

4. When installing an alloy saw blade, first confirm the performance and use of the saw table, and read the instruction manual of the saw table first. In order to avoid wrong installation and cause accidents.

5. When installing the alloy saw blade, first check whether the alloy saw blade is cracked, distorted, leveled, or lost teeth, etc., before installing.

6. The teeth of the alloy saw blade are super hard and sharp, and it is forbidden to collide or fall to the ground, and it must be handled with care.

7. After installing the alloy saw blade, you must confirm whether the center hole of the saw blade is firmly fixed on the flange of the saw table, and if there is a gasket, you must put the gasket on; then, push the saw blade gently by hand to confirm the rotation of the saw blade Whether it shakes eccentrically.

8. Align the cutting direction indicated by the arrow of the alloy saw blade with the rotation direction of the saw table. It is strictly forbidden to install in the opposite direction, as installation in the wrong direction will result in tooth loss.

9. Pre-rotation time: After replacing the alloy saw blade, it needs to be pre-rotated for one minute before use, so that the saw table can enter the working condition can it be cut.

10. Before cutting, confirm whether the use of the alloy saw blade is consistent with the material being cut.

11. When cutting material, gently drive the operating blade into the material and do not push hard or forcefully.

12. Reversal is prohibited. Reversal will cause tooth loss and cause danger.

13. When you hear abnormal sound during use, see abnormal shaking, or uneven cutting surface, please stop the operation immediately and find out the cause of the abnormality. Replace saw blade.

14. When cutting, it is forbidden to suddenly stop the saw blade in the middle of the cut object. Stopping in the middle of the cutting object will cause the teeth to fall off and the saw blade to deform.

15. Please wipe anti-rust oil in time after cutting. To prevent the saw blade from rusting.

16. When the sawtooth is not sharp, you need to grind the sawtooth again, and take it to the grinding shop designated by the manufacturer or a store with grinding technology for grinding. Otherwise, it will destroy the original angle of the sawtooth, affect the cutting accuracy and shorten the service life of the saw blade.