When using the circular saw blade milling cutter, you will encounter various problems, such as not being durable, chipped teeth or cracks in the substrate, so how should we deal with it, whether to scrap it for replacement or recycle it? Obviously All we have to do is to maximize the use of circular saw blade milling cutters to generate greater benefits for the enterprise.

1. Analysis and treatment of the undurable problem of circular saw blade milling cutter

A. Problem analysis

The saw blade is not durable, generally there is a problem with the equipment or the saw blade itself, we should overhaul the equipment carefully, if there is no problem, it is the quality problem of the saw blade itself, about this problem, you can refer to "Imported Saw Blade | Cold Saw Metal Round Analysis of the reasons for the undurability of saw blades》

B. Problem solving

If it is a problem with the saw blade, we should handle and maintain it according to the relevant instructions, check whether it needs to be ground or replace it, but if it is a manufacturing problem, we should communicate with the manufacturer to return it.

2. How to deal with the chipping problem of circular saw blade and milling cutter

A. Problem analysis

Chipping of saw blades and milling cutters is usually caused by poor sawing, and most of the factors causing this problem are due to debris on the saw teeth, or poor equipment operation, such as: loose screws, unstable flange or there are small iron filings entering the sawtooth parts, etc.

B. Problem solving

If the saw blade has chipped teeth, how should we deal with it?

1. Eliminate the factors of saw blade chipping and solve the fundamental problem, so as to ensure that the circular saw blade milling cutter will not cause secondary damage.

2. Clean the equipment to ensure that the fine iron filings are removed

3. Return the chipped saw blade to the manufacturer, and replace the saw tooth (tooth repair), so as to save the cost of use. The saw blade itself is composed of two parts: the base body and the saw tooth, and do not invalidate the entire saw blade due to a problem with a certain part.

3. Dealing with the problem of cracks in the base of the circular saw blade and  milling cutters

If there is a crack in the base of the saw blade and milling cutter, it will not be repairable. The best solution is to replace the saw blade. The base is the stable operation of the saw blade, and there is no way to repair it, so we must strictly follow the relevant regulations when using circular saw blades. The saw teeth can be replaced if they are damaged, and if the matrix is damaged, it can be said to be invalid , because the cost of changing the substrate is almost the same as buying a new one.