When metal circular saw blades are used, generally the sawing is stable, the cutting effect will be better, and the service life will be longer. If you find that the sawing is unstable, such as severe vibration, how should you deal with it? The following is some brief description on the problem.

1. The sawing vibration caused by poor equipment

When it is found that there is serious vibration when sawing with a metal circular saw blade, we should check whether the equipment is in good condition in advance. Most of these problems are caused by the equipment, or the saw blade is not installed correctly.

1. The vibration caused by the axial serial movement of the motor during sawing

2. If the fixture is not clamped or the material is too thin, special fixtures can be used

3. The metal circular saw blade was not installed correctly during installation, resulting in signs of looseness

4. It is a common sense problem that the saw blade does not correspond to the material to be cut or the model and specification of the equipment, and the corresponding situation should be checked repeatedly during use.

The above are some of the more common factors that cause the cutting instability of saw blades. According to different situations, different methods are used to avoid them. Strictly follow the instructions for operation,we should check whether the equipment is in good condition in advance and regularly clean and maintain it to improve sawing  efficiency.

2. Cutting vibration caused by quality problems of metal circular saw blades

There are several situations for this kind of problem. One is that the saw blade is not used according to the regulations, or the saw blade has been used for a long time, and the other is that the saw blade has quality problems during production.

1. It is a natural phenomenon that the saw teeth become blunt, because the saw blade is a consumable and needs to be reground or replaced after a certain period of use. When using, we should check the situation regularly to ensure the quality of cutting.

2. The angle is wrong. There are many types of saw teeth. For different equipment and materials, different metal circular saw blade milling cutters are required, which are similar to the model specifications.

3. There is a problem with the material used to make the saw blade. The more direct way to do this is to go to the supplier and contact the supplier for a replacement or a refund.

4. Another point is the material to be cut. If the unevenness is serious, it will inevitably vibrate during sawing. In this case, it is generally necessary to reverse the material to make it smooth before cutting.

No matter what the problem is, the metal circular saw blade milling cutter must ensure its sharpness. After installation, it must be idling for about 15 seconds to check that it is working properly before it can be used.