In order to make the saw blade play its best performance, it must be used in strict accordance with the specifications;

1. Saw blades with different specifications and uses have different design blade angles and saw blank, so try to use them according to their corresponding occasions;

2. The size and shape accuracy of the main shaft and splint of the equipment have a great influence on the use effect, so check and adjust before installing the saw blade. In particular, the factors that affect the clamping force on the contact surface between the splint and the saw blade and cause displacement and slippage must be eliminated;

3. Pay attention to the working condition of the saw blade at any time. If any abnormality occurs, such as vibration, noise, and material feeding on the processing surface, it must be stopped in time to adjust, and it must be repaired in time to maintain sharpness;

4. Do not change the original angle when grinding the saw blade, so as to avoid local sudden heat and sudden cooling of the blade head. It is best to ask professional grinding

5. Saw blades that are not in use for the time being should be hung vertically to avoid being placed flat for a long time, and objects should not be piled on top of it. The blade should be protected from collisions.

6. The equipment itself should have good mechanical properties, be firmly installed and fixed, and have no vibration;

7. The surface of the flange should be clean, flat and perpendicular to each other.

8. The diameter of the flange should be equal to or greater than 1/3 of the diameter of the saw blade used. If the flange is too small, even if the best saw blade on the market is used, unsatisfactory results will occur.

9. The main shaft of mechanical equipment should be flat and straight, and the tolerance should not be lower than the national standard. The national standard for the tolerance of the main shaft is ±0.01mm.

10. The saw blade has a blunt feeling. When grinding in an emergency, a diamond grinding wheel with a suitable particle size should be selected, and a coolant should also be used together; after grinding, the original cutting angle of the saw tooth should be maintained, and the back angle and saw board Grinding and adjustment should be done at the same time, so that satisfactory results can be achieved. At present, there are many grinding equipment on the market, but the accuracy and grinding conditions of the equipment itself cannot meet the requirements, let alone grinding good products.

11. Before using a new or ground saw blade, it should be idling for a cycle, and then check whether the saw blade is installed firmly to prevent the saw blade from slipping.

12. The reaming of the saw blade should not exceed the original aperture of 15mm. Because each saw blade manufacturer has adjusted the stress of the saw blade according to its diameter before the saw blade leaves the factory, otherwise it will cause loss of tension and the cutting effect of the saw blade will be affected. .

13. Choose a reasonable number of teeth, which is more conducive to the cutting effect and the extension of the service life of the saw blade.