1. Clean the area around the sliding table saw and workbench before turning on the machine. Check that the saw blade is vertical. When sawing a large area of wood, place the wood on the push table, flush with the reference baffle, adjust the positioning baffle, and then use a wooden frame to secure the wood firmly. Turn on the switch and feed the pusher at a constant speed. Don't push too hard or too fast. Operators should wear masks and noise-reducing earmuffs. Gloves and loose clothing are not allowed. Long hair needs to be pulled up. When the saw blade rotates, it is inconvenient to remove the wood next to the saw blade directly by hand. If necessary, use other longer pieces of wood to push it out of the way. 

2. When sawing small-sized wood, move the push table to a position that does not affect the operation, adjust the distance from the mountain, turn on the switch and feed at a constant speed. After sawing the wood for a short time, use the push rod to push the remaining wood onto the saw blade (depending on the distance between the wood to be processed and the saw blade). Accidents can be avoided to a large extent by using a push bar when cutting and grooving wood. 

3. When the cutting surface is too rough or has a peculiar smell, it should also be closed before inspection and maintenance.

4. The chip removal groove and listening device of the precision panel saw should be cleaned and maintained regularly to eliminate slag accumulation to ensure its flatness. Special reminder: If the precision panel saw is used for dry cutting, do not cut continuously for a long time to avoid damaging the saw blade. When using water cutting wet saw blades, be careful to prevent leakage 

5. When cutting aluminum alloys and other metals, special cooling and lubricating fluids should be used to prevent the saw blade from overheating and jamming, which will affect the cutting quality of the panel saw.

6. When using a woodworking precision panel saw, the workpiece should be in a fixed state, and the profile positioning should be strictly fixed in accordance with the cutting direction. The feed should be balanced and powerful, without side pressure or curved cutting, and without impact contact with the workpiece to avoid damage to the saw blade or safety accidents caused by flying out of the workpiece. When starting or ending a cut, do not feed too fast to avoid breaking teeth or damaging the precision panel saw blade. 

7. If there is abnormal noise or vibration during use of the woodworking precision panel saw, the equipment should be stopped immediately, and the fault should be checked for repair.