Tungsten carbide saw blade is a special saw blade for aluminum cutting machine. It can cut most of the aluminum profiles on the market, and the cutting effect is also very good, but it is inevitable to encounter some problems during use. For aluminum cutting machine saw blade Different problems should be dealt with accordingly.

 Problem analysis and treatment plan for abnormal sound

1. If abnormal sounds are found with the special carbide saw blade for aluminum cutting machine, it is likely that the saw blade is slightly deformed due to external factors or excessive external force, which triggers a warning.

Solution:

Re-calibrate the carbide saw blade.

2. The clearance of the main shaft of the aluminum cutting machine is too large, resulting in beating or deflection.

Solution:

Stop the device and check to see if the installation is correct.

3. There are abnormalities in the base of the aluminum cutting saw blade, such as cracks, blockage and distortion of the silencer line/hole, abnormal attachments, and other objects other than the cutting material during cutting.

Solution:

First determine where the problem lies, and deal with it according to different reasons.

The abnormal sound of the special hard alloy saw blade for aluminum cutting machine caused by the abnormal feeding

1. The most common cause of this problem is the slippage of the cemented carbide saw blade.

Solution:

readjust the saw blade

2. The spindle of the aluminum cutting machine is stuck

Solution:

Adjust the spindle according to the actual situation

3. The iron filings after sawing are blocked in the middle of the sawing road or in front of the material

Solution:

Clean up the iron filings after sawing in time

The sawed workpiece is unstable or the lines are too obvious or the burrs are too large.

1. This situation is usually caused by improper handling of the cemented carbide saw blade itself or the saw blade needs to be replaced, for example: the matrix effect is not up to standard, etc.

Solution:

Replace the saw blade or re-validate the saw blade

2. The side grinding of the sawtooth part is unqualified, resulting in insufficient precision

Solution:

Replace the saw blade or take it back to the manufacturer for regrinding.

3. The cemented carbide chip has lost teeth or is stuck with iron filings

Solution:

If it is tooth loss, the saw blade must be replaced and returned to the manufacturer for replacement. If it is iron filings, just clean it.

The above are the common problems and solutions of the special cemented carbide saw blades for aluminum cutting machines during use, for reference only.